If you’re looking for extremely low maintenance, check out this energy-saving pre-breaker that accepts large pieces without preliminary cut-up. Hardox machined teeth force material through it’s rugged anvils with a low speed shearing action instead of an impact or tearing action, and advanced controls help prevent and clear jams. Typically, the Precrushor can break up to a ton of material per horsepower per hour. Low motor speed makes the unit less vulnerable to metal damage while providing high rotor torque to handle a broad range of materials.

Prehogor™

Here’s a low cost answer to breaking up hard materials during primary size reduction. The Prehogor’s 17 welded, hard-faced rotor teeth and two anvil assemblies break materials into approximately 1" to 2" pieces. The first anvil assembly provides the initial breaking action, the second assures uniform sizing.

Hogor™

You can feed 20,000 to 60,000 pounds of material per hour through the Hogor’s large feed opening.

It can handle both soft and hard materials, providing the smallest , most uniform particle sizes averaging1/2". Optional 2", 3" or 4" diameter screens cut long, stringy material.

The high-speed, high capacity attrition type Dupps Grindor features a side entry housing for less windage. You can reduce dry material to small uniform pieces at an average rate of 100 pounds or more per horsepower per hour and moist material at 60 pounds per horsepower per hour.